Back to Projects

SquidGrip

A clamp-on USB-UART probe for programming ESP32 boards, built as a budget alternative to Tag-Connect. SquidGrip pairs a CP2102N USB-C bridge with a 6-pin 1.27mm pogo pin array on a thin tongue, and a 3D printed clamp presses that tongue onto the programming pads of a target board. The probe carries the ESP32 auto-reset circuit, so esptool, the ExpressLRS Configurator, PlatformIO, and the Arduino IDE can drop a target into its bootloader and flash it without you touching anything. Manual RESET and BOOT buttons, power/TX/RX status LEDs, and an onboard 3.3V LDO that can power the target board while it flashes round it out. It shows up as a plain serial port with no drivers needed, and the KiCad source, clamp CAD, BOM, and gerbers are open source under CERN-OHL-S-2.0.

ESP32 Programming Tool Pogo Pin PCB Design 3D Printing Open Source

Gallery

SquidGrip
SquidGrip
SquidGrip
SquidGrip
SquidGrip
SquidGrip
SquidGrip
SquidGrip

Interested in a similar project?

I'd love to discuss how I can help bring your ideas to life. Reach out with any questions or project ideas.